All timber surfaces should be thoroughly clean, dry and free from wax, oil, grease and other contaminants.  Fill all nail holes with a water based putty. Do not use linseed oil putty. Surface should be sanded in accordance with the Abrasive Manufacturers instructions.  Remove all sanding dust with a vacuum cleaner.  If the surface has been previously coated ensure that it is thoroughly sanded to remove old coating. 

Click here to see the advantages of using Feast Watson water based coatings.

Maxithane and Maxithane Non Yellowing can be used on concrete, flake floors and masonry.  Quickstep can also be applied as the sealer underneath these coatings.

Yes.  Click here to view application instructions on how to apply Prooftint under Enviromax.

Feast Watson Wet Edge Extender is an additive that increases the working time of all compatible moisture cured polyurethanes without affecting the thickness of the coating. Temperatures of 30°C and above,  high humidity and high airflow rates and large areas present wet edge challenges. Feast Watson Wet Edge Extender helps to overcome problems that could be caused by the coating drying too fast including poor leveling, blisters and the presence of lap marking. Note: It is not advised to apply coatings when the temperature exceeds 35°C as they may dry too quickly under the roller, resulting in a substandard finish.

 Rejection ranges from a change in a localised gloss level to an ‘orange peel’ appearance.  It is caused by contaminants leaching out of the flooring affecting the curing of the finish.

Yes, some Feast Watson sealers can be used under Enviromax and compatible* water based top coats.  If using Feast Watson Quickstep, sand before applying Enviromax.  Feast Watson Maxiprime can also be used.
 

Recoating of the floor is dependent on the amount of traffic the floor receives and the adherence to recommended maintenance schedules. Feast Watson Floorshine polish and Floor Clean are designed to help with restoring or maintaining the surface finish of your Feast Watson coated floors.

Feast Watson additives can be used in the top coats of compatible brands and products.  These can be accessed from the relevant product page on this site.

Feast Watson Quickstep with its high solids content (45% volume solids) and film build combined with quick drying time is the sealer that is best equipped at minimising the possibility of rejection.

Click here for a list of distributors stocking Feast Watson Commercial products.